Assembly instructions
1.
Prepare the holes in the ground at regular intervals of 2.0 รท 2.5 meters using a guide wire and a level to lay the posts. The starting post and the final post need to be equipped with reinforcing support post. In the presence of uneven ground, it is advisable to lay other reinforcing support posts, where necessary.
2.
Preparation of the wire tensioner: cut a piece of wire about 30 cm long. Insert one end in the thread tension hole and wrap vigorously on it for at least 3-4 times. The remaining part of the wire will be used to be tied to the starting post using the same technique. Note: cut the excess part and hide the wire ends as much as possible to avoid accidental abrasions.
3.
The tension wire is tied to the final post by means of another strong binding and will pass through all the posts in the appropriate pvc wire holders (as shown in the figure) and fixed to wire tensioner which will put everything in tension. Note: The wire tensioners will have to be pulled gradually only when the whole structure is completed.
4.
The wire mesh will be placed vertically at the starting post and tied with thin wires in several points and unwound and at regular intervals linked to the tension wires.
