General informations
The presence of two or more people is necessary for the correct laying of the fence
The use of at least 2 13 mm keys is required
The use of pincers and pincers is fundamental.
Assembly instructions
1.
Prepare the holes in the ground at regular intervals of 2.0 ÷ 2.5 meters using a guide wire and a level to lay the poles. The starting pole and the final pole will have to be equipped with reinforcing bolts. In the presence of overhanging or non-straight stretches, it is advisable to lay other reinforcing bolts, where necessary.
2.
Preparation of the wire tensioner: cut a piece of wire about 30 cm long. Insert one end in the thread tension hole and wrap vigorously on it for at least 3-4 times. The remaining part of the wire will be used to be tied to the starting post using the same technique. N.B. cut the excess part and hide the wire ends as much as possible to avoid accidental abrasions.
3.
The tension wire is tied to the final post by means of another strong binding and will pass through all the posts in the appropriate holes, anchoring itself to the previously blocked pass (as shown in the figure) which will put everything in tension. N.B. The wire tensioners will have to be pulled gradually only when the whole structure is completed.
4.
The net will be placed vertically at the starting post and tied with thin wires in several points and unwound and at regular intervals linked to the tension wires.
